Mitsubishi Electric MELSEC-Q Series User Manual page 116

[2] Precautions for CC-Link IE Field Network cable wiring
This section describes the CC-Link IE Field Network cable wiring and
precautions. For network configuration, cables, and hubs used for the wiring,
refer to the system configuration. (Refer to Chapter 2.)
(1) CC-Link IE Field Network cable connection
(a) Connecting the cable
1) Power off the Simple Motion module and the connected device.
2) Push the CC-Link IE Field Network cable connector into the
Simple Motion module until it clicks. Pay attention to the
connector's direction.
3) Power on the Simple Motion module and the connected device.
4) Check whether the LINK LED of the port connected with CC-Link
IE Field Network cable is on.
The time between the power-on and the LINK LED turning on may
vary. The LINK LED usually turns on in a few seconds. Note,
however, that the time may be extended further if the linkup
process is repeated depending on the status of the device on the
line.
If the LINK LED does not turn on, refer to the troubleshooting
section and take corrective actions. (Refer to Section 16.2.)
L ER
LINK
(b) Disconnecting the cable
1) Power off the system.
2) Press the latch down and unplug the CC-Link IE Field Network
cable.
Chapter 4 Installation, Wiring and Maintenance of the Product
4 - 14