Mitsubishi Electric MELSEC-Q Series User Manual page 257

Set with a decimal.
Setting value
K 1
After the M code ON signal turns OFF, "0" is stored by the Simple Motion
module automatically. (Indicates that the OFF request is completed.)
Set with a decimal.
Setting value
K
Set with a decimal.
Actual value
Cd.9 New current value
Conversion into an integer value
10
Setting value
R
(Decimal)
Set with a decimal.
Cd.10 New acceleration time value
Setting
value
Cd.11 New deceleration time value
Example: When the " Cd. 10 New acceleration
time value" is set as "60000 ms", the
buffer memory stores "60000".
Setting value
M code OFF request
1: M code ON signal turns OFF
External command valid
0: Invalidates an external command.
1: Validates an external command.
Unit conversion table ( Cd.9 )
m
m
1
5
5
0
5 - 137
Chapter 5 Data Used for Positioning Control
Default
Buffer memory address
value
0
0
0
Unit
m
inch
degree
PLS
0
0
4304+100n
4305+100n
4306+100n
4307+100n
4308+100n
4309+100n
4310+100n
4311+100n
n: Axis No.-1