Mitsubishi Electric MELSERVO-J2S Series Transition Handbook page 320

Part 7: Common Reference Material
MR-J2S-_CL_
No. Name
Program input polarity selection
77
1
84 For manufacturer setting
85 For manufacturer setting
- -
-
MR-J4-_A_-RJ
Type Target No. Type
Hex _ X _ _ PT29 Hex
_ _ _ X
_ _ _ X
PD01 Hex
_ _ X _
_ _ X _
_ X _ _ PD41 Hex
Hex _ X _ _
_ X _ _ PD42 Hex
X _ _ _
X _ _ _
PD41 Hex
X _ _ _
X _ _ _
PD01 Hex
Hex _ _ _ X
- - PA21 Hex
Hex
Hex
- - PA01
Hex
Hex
Hex: hexadecimal parameter; Dec: decimal parameter
7 - 81
Conversion rule
Target
_ _ X _ The setting value will be maintained.
The setting value will be converted to the
X _ _ _ manufacturer setting value. Do not change the
setting value.
The setting value will be converted to the
_ _ _ X manufacturer setting value. Do not change the
setting value.
The setting value will be converted to the
_ X _ _ manufacturer setting value. Do not change the
setting value.
The setting value will be converted to the
_ X _ _ manufacturer setting value. Do not change the
setting value.
The setting value will be converted to the
_ _ _ X manufacturer setting value. Do not change the
setting value.
The setting value will be converted to the
_ X _ _ manufacturer setting value. Do not change the
setting value.
The setting value will be converted to the
_ X _ _ manufacturer setting value. Do not change the
setting value.
The setting value will be converted to the
_ X _ _ manufacturer setting value. Do not change the
setting value.
The setting value will be converted to the
_ X _ _ manufacturer setting value. Do not change the
setting value.
The setting value will be converted to the
_ _ X _ manufacturer setting value. Do not change the
setting value.
The setting value will be converted to the
_ _ X _ manufacturer setting value. Do not change the
setting value.
The setting value will be converted to the
_ _ X _ manufacturer setting value. Do not change the
setting value.
3 _ _ _ will be set.
X _ _ _
To use the HC/HA series servo motors without
being replaced, refer to (5) in Section 2.3.5.
_ _ _ X _ _ _ 7 will be set. (Program method)
_ _ X _ _ _ 0 _ will be set. (Standard control mode)
_ X _ _ _ 0 _ _ will be set.
X _ _ _ 1 _ _ _ will be set.