NEC IntraMail 4 System Manual page 13

Step 6 Install the IntraMail PCB
- Attach a grounded wrist strap to a known earth ground.
■
- Discharge any built-up static electricity by touching the cabinet ground lug.
- Plug in the IntraMail PCB as shown below.
■
Step 7 Replace and re-secure the top panel.
Step 8 Complete the reinstallation.
- Hang the cabinet back on the wall.
- Reinstall all extension, trunk, and auxiliary cabling.
- Replace and lock the cover.
- Plug in the system and turn on the system power.
Step 9
Verify IntraMail operation.
- After the system restarts, go to any keyset and press
■
IntraMail System Guide
(Figure 4: Installing the IntraMail PCB in DS1000)
Use the cabinet ground lug if the ground wire is still connected.
Be sure to snap the PCB into the supplied plastic standoffs.
Figure 4: Installing the IntraMail PCB in DS1000
You should immediately log into that extension's mailbox and hear the voice prompt, " You have
no new messages. "
Installation
DS1000 Installation
.
.
MW
Chapter 1: Quick Setup ◆ 3
1