Installation
DS2000 Installation
DS2000 Installation
Installing IntraMail in DS2000
Step 1
Step 2
- Unscrew the two captive screws on the front cabinet cover.
- Lift up slightly on the front of the cover — then gently slide the cover back to remove it.
Step 3
- Attach a grounded wrist strap to a known earth ground.
- Discharge any built-up static electricity by touching the cabinet ground lug.
- Unplug and label the CPU cabling (if installed).
- Remove the CPU and place it on a flat, anti-static surface.
4 ◆ Chapter 1: Quick Setup
Power down the system.
(Figure 5: Removing the DS2000 Cover)
Remove the cover
Figure 5: Removing the DS2000 Cover
(Figure 6: Removing the DS2000 CPU)
Remove the CPU PCB
Figure 6: Removing the DS2000 CPU
.
4 Slot Cabinet Shown
.
4 Slot Cabinet Shown
IntraMail System Guide