Message Waiting Lamp - NEC IntraMail 4 System Manual

Message Waiting Lamp

Message Waiting Lamp
Description
In software version 03.20.07 and higher, the MW LED is used only for Call Screening. In software ver-
Software
sions prior to 03.20.07, an extension's MW LED would flash when there were new messages waiting in
Note:
the mailbox.
An extension's Ring/Message Lamp flashes on the telephone to indicate that the user has new messages
waiting in their mailbox. Once IntraMail is properly installed and programmed, telephone Ring/Message
Lamp operation is automatic. The Ring/Message Lamp will flash fast when there are new messages in the
extension user's mailbox. The Ring/Message Lamp is a visual reminder of new messages. The subscriber
does not have to call their mailbox and listen to the voice prompts to find out when they have new messages.
In software versions prior to 03.20.07, an extension's MW LED would also flash when there were new messages
waiting in the mailbox. In software version 03.20.07 and higher, the MW LED is used only for Call Screening.
Related Features
Call Screening (page 53)
With the introduction of Call Screening in software versions 03.20.07 and higher, only the Ring/Message
Lamp flashes for new messages. The MW LED is used for Call Screening only.
Programming
Step 1
Operation
N/A
146 ◆ Chapter 2: Features
Turn Message Waiting lamping for Subscriber Mailboxes on or off.
1808 - IntraMail Subscriber Mailbox Options: Message Waiting Lamp on page 204.
1.1
- Enter N (6) to disable Message Waiting lamping.
- Enter Y (9) to enable Message Waiting lamping.
- If Message Waiting lamping is disabled (N), Message Notification will not function.
✔
By default, this option is Y (9).
IntraMail System Guide