Toro Greensmaster TriFlex 3300 Manual page 137

2. Use the Toro DIAG software to reprogram the machine in accordance with Toro DIAG User's Guide. The
replacement cutting reel motor is programmed during the reprogramming of the machine.
3. Disconnect the Toro DIAG cable from the machine.
4. Install the left-hand cover assembly.
5. Go to Returning the Machine to Service (page 21)
Pass The machine functions properly with no faults after reprogramming. Go to
to Service (page 21)
Fail The machine has been reprogrammed and the fault still exists. Repeat the diagnostic process.
Electrical Diagram
and follow the steps listed.
Figure 83
137
and follow the steps listed.
Returning the Machine
g334749