Fault 63: Id Module Fault - Toro Greensmaster TriFlex 3300 Manual

Fault 63: ID Module Fault

InfoCenter Display:
Fault Description
This fault is reported when an internal digital location ID code (address) is missing from a component, or if more
than 1 cutting reel motor reports having the same CAN ID as the primary TEC. The primary TEC controller has
recognized at least one of the cutting unit electronic addresses is outside of the standard range.
Circuit Description
The location ID module exists in the electric cutting reels circuit to identify the location of each of the three
cutting reel motors. This module allows machine features such as raising the center cutting unit slightly later
than the front cutting units, and monitoring of specific reel performance by location. The location module plugs
into the e-reels wire harness under the left side cover, next to the operator seat.
Recommended Service Actions
Step 1: Verify that the fault repeats.
1. Clear the system faults from the InfoCenter. Refer to
2. Operate the machine.
Pass The fault did not repeat. Go to
Note:
If the fault does not repeat, an isolated event has occurred.
Fail The fault repeated. Go to Step 2.
Step 2: Test the resistance of the ID module.
The ID module is located underneath the left-hand cover assembly
TriFlex 3320/3420 Service Manual, Chapter 6, Location ID Module section, and test the ID module.
_____FAULT #63_____
ID MODULE FAULT
Clearing Faults from the InfoCenter (page
Returning the Machine to Service (page 21)
166
and follow the steps listed.
(Figure 93). Refer to the Greensmaster
19).