Toro Greensmaster TriFlex 3300 Manual page 203

1. Right front tire
2. Operator seat
1. Remove the right side cover and gain access to the back of the key switch.
2. Unplug the connector from the rear of the key switch (P50).
3. Remove the four mounting bolts that secure the primary TEC-5001 controller (see
4. Lift the primary TEC up and out of its mounted location.
5. Fully loosen the socket-head screw that secures main harness connector P01 to the TEC and then
unplug the connector (see
6. Use a multimeter to test the resistance between the following pair of locations:
Location Harness
1 Main
2 Main
Figure 126).
Connector Pin
P01 25 Yellow (Y)
P50 4 Yellow (Y)
Figure 125
3. Primary TEC-5001 controller
4. Mounting bolts (2 of 4 are shown)
Wire Expected
Color Reading
less than
2 ohms
203
Figure 125).
Connector Graphic
g237658