Step 5: Use Toro DIAG to program the S/G.
1.
Connect a PC with Toro DIAG software to the machine via a Toro DIAG Cable (Part No. 115-1944). Refer
to
Toro DIAG–Quick Start (page
2.
Use the Toro DIAG software to reprogram the machine in accordance with Toro DIAG User's Guide. The
replacement S/G controller is programmed during the reprogramming of the machine.
3.
Once programming is complete, disconnect the Toro DIAG cable from the machine.
4.
Go to
Returning the Machine to Service (page 21)
22).
and follow the steps listed.
43