Toro Greensmaster TriFlex 3300 Manual page 314

1. Joystick
2. Joystick raise switch
3. Main harness connector P13
Step 4: Test the joystick switches.
1. Unplug main harness connector P13 from the joystick raise switch
2. Using a multimeter, measure the resistance between pin 1 and pin 2 of the switch
1. Pin 1
2. Pin 2
•
With the switch lever pushed, the reading should be 0 ohms.
•
With the switch lever released, the reading should be infinite ohms.
3. Repeat substeps 1 and 2 with main harness connector P14 and the joystick lower switch
Pass The resistance measurements were good. Go to Step 5.
Fail One or more of the resistance measurements were not good. Repair or replace worn or damaged
parts as required. Go to
Figure 173
4. Joystick lower switch
5. Main harness connector P14
Figure 174
3. Pin 3 (not used)
4. Switch lever
Returning the Machine to Service (page 21)
314
(Figure 173).
(Figure
(Figure
and follow the steps listed.
g242643
174).
g242644
173).