Fault 143: Software Incompatible - Reel Motor 3 - Toro Greensmaster TriFlex 3300 Manual

Fault 143: Software Incompatible – Reel
Motor 3
InfoCenter Display:
Fault Description
This fault is reported when the controller software in cutting reel motor 3 is incompatible with the software in the
primary TEC-5001 controller.
Circuit Description
There are multiple controllers in this machine, including the primary TEC-5001 controller and individual
controllers within each cutting reel motor. There are additional individual controllers within the starter/generator
unit and the InfoCenter. All of these controllers must have compatible software for the machine to function
correctly.
Recommended Service Actions
Step 1: Verify that the fault repeats.
1. Clear the system faults from the InfoCenter. Refer to
2. Operate the machine.
Pass The fault did not repeat. Go to
Note:
If the fault does not repeat, an isolated event has occurred.
Fail The fault repeated. Go to Step 2.
Step 2: Use Toro DIAG to reprogram the machine.
Use Toro DIAG to reprogram the machine. If the first attempt to reprogram the machine is unsuccessful, try
reprogramming the machine a second time.
1. Connect a PC with Toro DIAG software to the machine via a Toro DIAG Cable (Part No. 115-1944). Refer
to Toro DIAG–Quick Start (page
2. Use the Toro DIAG software to reprogram the machine in accordance with Toro DIAG User's Guide. The
cutting reel motor is reprogrammed during the reprogramming of the machine.
3. Disconnect the Toro DIAG cable from the machine.
Pass
If reprogramming the machine was successful, go to
and follow the steps listed.
Fail If both attempts to reprogram the machine are unsuccessful, contact the Toro Assistance Center
(TAC).
_____FAULT #143____
3 - SOFTWARE
Clearing Faults from the InfoCenter (page
Returning the Machine to Service (page 21)
22).
321
and follow the steps listed.
Returning the Machine to Service (page 21)
19).