Sip Mlt Firmware Upgrade - NEC UNIVERGE SV9100 Manual

100
Firmware Upgrade
Below is an example of how to use IP Phone Manager to upgrade the firmware of SIP MLT's
Conditions
1. The terminals must be operational.
2. The IPPhoneManager must be located in the same network segment the terminals are in (only if
using the Search function).
3. Running FTP/TFTP Server containing correct firmware files.
Procedure:
1. Start up the IPPhoneManager
2. Press 'Search' in 'Registration' (Import or Direct may also be used)
3. Press 'Select ALL' (or individually select the phones to be upgraded)
4. Press 'Connect'
5. Select 'Download' in 'Command'
6. Press 'Execute'
7. Enter information in 'FTP/TFTP Server'
8. Select 'Boot&Program' in 'Download File Type'
9. Press 'Select All'
10. Press 'Download'.
The handsets will now download and save the firmware then reboot and reconnect to the SV9100.
2.5.1.5

SIP MLT Firmware Upgrade

SIP MLT Firmware Upgrade
From time to time it may be necessary to upgrade the firmware on the SIP MLT handsets, possibly to
introduce new features.
There are several ways in which the upgrade can be performed, these are listed below.
Using IP Phone Manager (TFTP/FTP server required)
Using the SIP MLT menu (TFTP/FTP server required)
Automatic upgrade whilst the phone is registering to the SV9100 (SV9100 programming and
TFTP/FTP server required)
To show the current firmware version of a SIP MLT on its display use the following steps: -
1. Press and hold the Help key for two seconds.
2. Press 2 for System Information.
3. Press 5 for Terminal Information. The Hardware Version is displayed at this point.
4. Press the Down softkey several times until 'Firmware Version' is displayed.
5. To exit the menu press the Exit key or press the Prev softkey twice then the Exit softkey.
For instructions on using the IP Phone Manager please refer to the IP Phone Manager page.