NEC UNIVERGE SV9100 Manual page 171

Register Error
NetLink ###:SIP(XX) REG FAILED($$$) ###:Alarm number (60)
Disabled
NetLink ###:SIP(XX) REG NG($$$) -%
Enabled %
Register Authentication Error
NetLink ###:SIP(XX) AUTH
Disabled FAILED($$$)
NetLink ###:SIP(XX) AUTH NG($$$) -%
Enabled %
Comments
It is not possible to program a Secondary system via handset programming when NetLink is
operational.
SIP trunk port numbers are assigned from the next available port number (the same as current
operation).
Previous assignments of SIP Trunk ports may be disabled when NetLink is first configured.
The total number of SIP trunks assigned to all systems in the NetLink network must not exceed
the number of licenses installed on the Primary system. If the number of trunk ports exceeds the
number of licenses then the SIP trunks will fail to be assigned port numbers.
Any node in NetLink can use the SIP trunks on its own node or on any other node (depending on
system programming).
Incoming/Outgoing SIP Trunk for E.164
SIP Trunks now have the ability to communicate with an external SIP carrier using E.164 number
formatting. When a user makes an outgoing call via SIP trunk from the system, it can be configured to add
a '+' character and country code to the SIP Request-URI, To, From, P-Asserted Identity, and P-Preferred
Identity header fields of the SIP message. This requirement may be necessary for connection to specific
SIP carrier providers.
Enable Incoming/Outgoing SIP Trunk for E.164 by using the 'Incoming/Outgoing SIP Trunk for E.164' option
in Easy Edit – Advanced Items/VoIP/SIP Networking/Profile x/SIP Profile x - Trunk General Settings/SIP
Profile x - E.164 Numb er Formatting/SIP Profile x - E.164 Numb er Format Settings
When PRG84-14-13 is set to Enabled, then for any out bound call via SIP trunk a '+' and the Country Code
in PRG10-02-01 (if configured in system programming) is added to the beginning of the Request-URI, To,
and From header fields.
PRG 84-14-13
PRG 10-02-01
Incoming/Outgoing
Country Code
SIP Trunk for
E.164
0
Format
XX:Register ID (1-32)
$$$:Err code (000-999)
%% System ID (1-16)
Format
###:Alarm number (60)
XX:Register ID (1-32)
$$$:Error code (000-999)
%% System ID(1-16)
44 Request-URI: Invite sip:0356551700@172.16.18.100 SIP/2.0
Part 2: VoIP Manual
Key Terminal LCD Example
"60:SIP(07) REG FAILED(403) "
"60:SIP(07) REG NG(403) -02 "
Key Terminal LCD Example
"60:SIP(20) AUTH
FAILED(401)"
"60:SIP(20) AUTH NG(401) -02"
Example Outgoing SIP Message
(user dials "0356551700")
171