Aspirenet - NEC UNIVERGE SV9100 Manual

2.6.2

AspireNet

AspireNet
The SV9100 uses the GPZ-IPLE card or PRI card to connect multiple systems together over a Data
Communication IP Network (Intranet). AspireNet is used to provide telephony services between the
SV9100 and other SV9100's, SV8100's or Aspire systems.
There can be up to 16 Nodes in an AspireNet Network.
The station and trunk ports are independantly allocated from the local CPU so extensions and trunks are
dependant of the maximum capacities of each system.
Each system in the network must have:
GCD-CP10
GPZ-IPLE or PRI card
Feature Networking (Aspirenet) license(s):
It is advisable to have compatible levels of system software installed on all systems within the Network.
Although the basic AspireNet will operate correctly there could be problems with features that are only
available from a given level of software.
AspireNet Easy Edit Programming
AspireNet IP Setup
Easy Edit – Advanced Items/VoIP/Networking/AspireNet CVM/AspireNet Setup/AspireNet IP Setup
IPL IP Address – This is the signalling address of the SV9100's own GPZ-IPLE card
IPL Subnet Mask – This is the subnet mask of the SV9100's own IPL card
Default Gateway – This is the IP address of the default gateway on the SV9100's own network
02)
Networking System – This is the TCP port that the SV9100 uses
Fast Start – This is a component of the H.323 protocol. This must be enabled for AspireNet
AspireNet address for Remote
Easy Edit – Advanced Items/VoIP/Networking/AspireNet CVM/AspireNet Setup/AspireNet address for
Remote (PRG10-12-27)
Against the Networking System ID (1 – 50) enter the IP address of the remote systems GPZ-IPLE or
VoIPDB.
AspireNet VoIP Resource IP Address Setup
Easy Edit – Advanced Items/VoIP/Networking/AspireNet CVM/AspireNet Setup/AspireNet IPL VoIP
Resource IP Address (PRG84-26)
For an GPZ-IPLE card only one address is required regardless of the number of voip channels licensed.
For the RTP and RTCP ports enter the starting port number for each IP address. Each DSP requires one
RTP port and one RTCP port. Under normal circumstances there is no need to change these settings from
default.
AspireNet ISDN setup
For configuration of the PRI card for AspireNet connection refer to the following Easy Edit page:
Part 2: VoIP Manual
BE114066
(PRG10-12-10)
135
(PRG10-12-09)
(PRG10-12-