NEC UNIVERGE SV9100 Manual page 179

SIP Trunk SIP - URI E.164 Incoming Mode - Defines the settings for additional SIP support of incoming
E.164 number formatting when used in conjunction with incoming caller history.
Disabled - The system will delete the + only from the incoming call URI
M ode 1 – When an incoming call has a + and Country Code other than what is defined in 10-02-01 then deletes the +
and adds the International Access Code in 10-02-02. If a call comes in with a + and the Country Code assigned in 10-
02-01 then deletes the + and Country Code and does not add the International Access Code from 10-02-02.
M ode 2 - When an incoming call has a + and Country Code other than what is defined in 10-02-01 then deletes the +
and adds the International Access Code in 10-02-02. If a call comes in with a + and the Country Code assigned in 10-
02-01 then deletes the + and Country Code and adds the Caller ID Edit Code in 10-02-03.
Note:
PRG10-29-16 Register Sub Mode if enabled might cause the SV9100 to reject incoming SIP Trunk calls
depending on other settings. If problems are experienced with incoming calls being rejected turn this item
off.
Configuration Examples
The examples below are for general information only, they will not work for all SIP carriers. Please refer to
the relevant 'SIP Certificate of Compatibility' for specific information.
Carrier Mode IP Address
Command
10-12-01
10-12-02
10-12-03
10-12-07
10-12-09
10-12-10
10-28-01
10-28-02
10-28-05
10-29-01
10-29-02
10-29-03
10-29-05
10-29-06
10-29-21
Entry
192.168.0.10
255.255.0.0
172.16.0.1
<Public IP Address>
172.16.0.10
255.255.0.0
nec.co.uk
SV9100
IP Address
Enabled
Enabled
<ITSP IP Address>
Manual
<ITSP IP Address>
Used
Part 2: VoIP Manual
(PRG84-14-16)
179