NEC UNIVERGE SV9100 Manual page 150

150
Operation
To Set a Function Key to your Hotline partner:
1. Press Speaker to go off hook.
2. Dial service code 851.
3. Press Hotline key + partner's extension number + HOLD.
To place a call to your Hotline partner:
1. Press Hotline key
You can optionally lift handset after this step for privacy.
To transfer your outside call to your Hotline partner:
1. Press Hotline key.
2. Announce call and press the Transfer button.
OR
Press Transfer to have the call wait at your Hotline partner unannounced.
If unanswered, the call recalls like a regular transferred call.
To answer a call from your Hotline partner:
1. If you hear two beeps, speak toward phone.
OR
2. If your telephone rings, lift handset.
Calling an extension from your 110 button DSS Console:
1. Press EXT.1 or EXT.2 to select the range.
2. Press DSS Console key.
If the call voice-announces, you can make it ring by dialling 1.
If you don't have Handsfree, you must lift handset to speak.
Intercom
An extension user can make an intercom call to a networked system if the networked extensions are
defined in system programming.
A user can change the signalling type for the intercom call they place to either a voice announce or ringing
call when calling an extension in a networked system.
Operation
To place an Intercom call:
1. At system phone, press Speaker.
OR
At single line telephone, lift handset.
2. Dial extension number (or 0 for your operator).
Your call may voice-announce or ring the called extension. Dial 1 to change the way your call alerts the
called extension.
If the extension you call is busy or doesn't answer, you can dial another extension without hanging up.
Keep Alive Operation
The Keep Alive operation will check that the distant end is available. A message is sent that the distant end
must respond to, if no response is received the line will be taken out of service.
Operation
The response to the keep alive message is automatic.
The generation of the keep alive message is set in system programming. If the timer is set to 0 the keep
alive generation is turned off.
The retry count for a keep alive message that is not responded to is also set at the originating system.
The line will be placed back in service when the line is active and a keep alive message is responded to.
The keep alive operation will only take place if the message is sent and not responded to by the distant