NEC UNIVERGE SV9100 Manual page 152

152
Press Message Waiting key (SC 851: 38).
OR
At single line telephones, lift the handset and dial 841.
Normally, your MW LED goes out. If it continues to flash, you may have new messages in your "Voice Mail"
mailbox or a new "General Message".
Operator, Centralised
It is possible to have a centralised network operator extension that can be dialled with the operator access
code (0).
Calls to the operator will be queued and answered in order. Up to 32 calls can be queued at the operator
extension. The quantity of network calls that can queue at the operator may be limited by the quantity of
networking channels available.
Operation
The network numbering plan must be set up to route the operator access code (0) to the system that has
the operator extension.
The operator extension must be set in system programming.
If the operator's extension is connected to system A the following settings are required:
At System A the required extension must be set as the operator extension.
At system A dial 0 must be set as Operator.
At system B dial 0 must be set as Networking System Access and routed to the node ID of System
A.
Users at System A and B can access the operator by dialling 0.
Paging
An extension user can make internal or external pages to a networked system. Paging to a networked
system can only be activated by dialling a service code and the target network's system ID.
Operation
To Make an Internal Page
1. Dial 801.
2. Dial # and the system ID (01 to 50).
The system ID must be dialled as 2 digits (ex: #02).
3. Dial the Paging Zone number (00-64).
Dialling 00 calls All Call Internal Paging.
4. Make announcement to the networked system.
5. Press SPK to hang up.
To Make an External Page
1. Dial 803.
2. Dial # and the system ID.
The system ID must be dialled as 2 digits (ex: #02).
3. Dial the Paging Zone number (0-9).
Dialling 0 calls All Call External Paging.
4. Make announcement to the networked system.
5. Press SPK to hang up.
To Make a Combined Page
1. Dial 751.
2. Dial # and the system ID.
The system ID must be dialled as 2 digits (ex: #02).
3. Dial the Paging Zone number (0-9).
Dialling 0 calls All Call Combined Paging.