NEC UNIVERGE SV9100 Manual page 59

There are several different codec's available for use on the SV9100 as listed below.
G.711 (64kbps)
G.722 (64kbps)
G.726 (32kbps)
G.729 (8kbps)
Not all of these codec's are available for all VoIP applications, refer to the relevant section of this manual
for further information.
VoIP Gateways
The current GPZ-IPLE daughter board requires a single DSP IP address.
Ethernet Status
The connection status of the GPZ-IPLE Ethernet connection can be determined by observing the four LED's
on the GPZ-IPLE VoIP card. The LED indications depend on whether there is an GPZ-IPLE VoIP card
installed or an GPZ-IPLE VoIP card installed. Please refer to the GPZ-IPLE Differences page for further
information.
GPZ-IPLE Daughter Board
The current GPZ-IPLE daughter board requires a single DSP IP address.
The IPLE daughter board provides:
256 (GPZ-IPLE) channels
Refer to the following tables for maximum upgrade capacities of the
GPZ-IPLE daughter board:
Table 2-6 SV9100 Maximum 9.5" Gateway and 19" System
Capacities – Blades on page 2-12
Table 2-7 SV9100 Maximum 9.5" Base and Expansion System
Capacities – Blades on page 2-14
When installing an IPLE daughter board, the system allocates the maximum
number of trunk ports for the blade being installed.
The IPLE does not have any DSP limitations based on CODEC settings.
Part 2: VoIP Manual 59