Sip Mlt Ip Phone Manager - NEC UNIVERGE SV9100 Manual

2. At the Login screen, enter the user name (default = ADMIN) and password (default = 6633222)
and press the OK softkey.
3. Press 1 for Network Settings.
4. Press 6 for Advanced Settings.
5. Press 4 for Type Of Service.
6. Press 1 for RTP.
7. Enter the hexadecimal value for the required ToS and press the OK softkey.
8. Press 2 for SIP.
9. Enter the hexadecimal value for the required ToS and press the OK softkey.
10. Press the Exit softkey three times.
11. Press the Save softkey.
12. The handset will reboot and reconnect to the SV9100.
Setting ToS Values using the SV9100 Programming
There are two items in system programming, one for SIP signalling and one for RTP.
For SIP signalling use the Type of Service option in:
Easy Edit – Advanced Items/VoIP/Extensions/DT800 DT700 Setup/DT800 DT700 Setup. (PRG84-23-06)
For RTP use the Media ToS item in:
Easy Edit – Advanced Items/VoIP/Extensions/DT800 DT700 Setup/DT800 DT700 Setup. (PRG84-23-13)
When the SIP MLT registers to the SV9100 it will read these ToS values and use them from that point
onwards.
Using this method every SIP MLT registered to the SV9100 will have the same ToS values.
Considerations
If the SIP MLT is set to mark the frames/packets with QoS information this is only applied to the information
being sent from the SIP MLT. The SV9100 must also be set to mark the frames/packets that it sends out to
the SIP MLT.
For any type of QoS to function correctly the network that the devices are connected to must support the
same protocol that the devices are using. The network must also be set up correctly to allow priority for this
traffic over other traffic on the network. This must be done throughout the entire network.
Liaise with the network administrator to ensure this is implemented correctly.
2.5.1.4

SIP MLT IP Phone Manager

SIP MLT IP Phone Manager
IP phone manager is a maintenance application for SIP MLT extensions.
It can be used for several functions such as initiating file downloads, creating configs, changing settings,
backing up configs etc.
INSTALLATION
Follow these steps for installation of the IP Phone Manager.
1. Double Click Setup.exe icon to initiate the installation.
2. After installation, a Shortcut is placed on your PC Desktop. This icon can be used to run the IP
Phone Manager application.
3. At the elect Interface Pop Up, select the active Network Interface Card that your PC is currently
Part 2: VoIP Manual 93