NEC UNIVERGE SV9100 Manual page 243

Voice over ip
Hide thumbs Also See for UNIVERGE SV9100:
Table of Contents

Advertisement

1.
Lift the handset or press Speaker.
2.
Dial the remote K-CCIS station number.
To call a station at another office using Numbering Plan 2 (Open Numbering Plan):
1.
Lift the handset or press Speaker.
2.
Dial the trunk Access Code.
3.
Dial the Office Code number.
4.
Dial the remote K-CCIS station number.
Service Conditions
General:
In a closed numbering plan, the location of the office can be identified by the first digit or first two
digits of the telephone number.
In an open numbering plan, each office in the K-CCIS network is assigned a one-, two- or three-
digit office code and each station in the office is assigned telephone numbers from two to eight
digits.
In the same office, a station-to-station call is made by dialling the telephone number of the
desired station.
Restrictions:
For a Closed Numbering Plan network, a maximum of 255 systems can be connected per K-CCIS
Network.
When a Closed Numbering plan is used the extensions in the network cannot have the same
prefix number.
For an Open Numbering Plan network, the Automatic Route Selection (ARS)/ Flexible Routing (F-
Route) feature must be used to place Station-to-Station calls over K-CCIS.
When an Open Numbering plan is used, the extensions in the network can have the same prefix
number, however the office location number cannot be the same.
Related Feature List
Call Transfer – All Calls – K-CCIS
Flexible Numbering of Stations – K-CCIS
Key-Common Channel Interoffice Signalling (K-CCIS)
Station-to-Station Calling – K-CCIS
Guide to Feature Programming
Refer to Flexible Numbering of Stations feature
Voice Call – K -CCIS
Feature Description
This feature provides a voice path, through the K-CCIS network, between a MLT in one office and a MLT in
another office. This path is established from the calling party to the called party built-in speaker. If the called
party MIC is on, the called party can converse hands-free.
System Availability
Terminal Type:
All multiline terminals
Required Components:
GPZ-IPLE
Part 2: VoIP Manual
243

Advertisement

Table of Contents
loading

Table of Contents