NEC UNIVERGE SV9100 Manual page 193

Any Call Back's that are set will be removed by a system reset.
One extension can receive Call Back settings from multiple extensions. In this case the ring back
will occur in the order they were set.
If the Call Back destination has a Call Forward set the operation is as follows: -
If the Call Forward destination is an internal extension – Call Back will be established to the
o
Call Forward destination.
If the Call Forward destination is another system or trunk – Call Back will not be established.
o
Related Feature List
Station-to-Station Calling – K-CCIS
Uniform Numbering Plan
Guide to Feature Programming
This guide provides a list of associated Programs that support this feature.
PRG15-07 (Code: 35).
PRG20-01-07 Camp On Extension Call Back Time.
PRG20-01-09 Camp On Cancel Time.
PRG20-13-35 Block Camp On.
Call Forwarding – All Calls – K-CCIS
Feature Description
This feature allows all calls destined for a particular station to be routed to another station or to an
Attendant, in another office in the K-CCIS network, regardless of the status (busy or idle) of the called
station. The activation and cancellation of this feature may be accomplished by either the station user or an
Attendant position if allowed by Class of Service (COS). Attendant Positions can be used to cancel Call
Forward – All Call system-wide.
For more details, refer to the UNIVERGE SV9100 Features and Specifications Manual.
System Availability
All multiline terminals
Required Components
GPZ-IPLE
Operating Procedures
To set Call Forward – All Calls – K-CCIS from a multiline telephone (Closed Numbering plan):
1. Press the Call Forward – All ON/OFF key.
2. Dial 1 to set, then enter the remote K-CCIS station number.
3. Press Speaker.
- OR -
1. Lift the handset or press Speaker.
2. Dial Access Code 848 (default), then 1 to set.
3. Dial the remote K-CCIS station number.
Part 2: VoIP Manual 193