Sip Mlt Factory Default - NEC UNIVERGE SV9100 Manual

108
7. Click ADD, and provide the following information:
8. Click on ADD, and give the following information:
Option 151 is for DT700 Economy/Value/Sophisticated terminals (ITL-2E,ITL-6DE,ITL-
8LDE,ITL-12PA,ITL-12D,ITL-24D,ITL-32D,ITL-320C)
Option 152 is for DT700 Gigabit Colour/Grayscale terminals (ITL-12CG,ITL-12DG)
Option 153 is for DT800 Value terminals (ITZ-8LDG,ITZ-12D,ITZ-24D,ITZ-12DG,ITZ-12CG))
Configuring Options
1. Highlight scope options on the left side. Then right click and choose Configure Options.
2. Click Advanced and change the vendor class to NECDT700.
3. Place a check mark next to 141 FTP Address. Down below assign the IP address of the FTP
server. Then click Apply.
4. Place a check mark next to 151 auto config file name. Enter the name of the config file created
using IP Phone Manager. Then click Apply.
5. Place a check mark next to 163 download protocol. Down below change the HEX address to be
0x1.
6. Click on Apply and OK.
2.5.1.7

SIP MLT Factory Default

SIP MLT Factory Default
SIP MLT handsets can be restored to factory default settings in several ways:
Handset programming
Web Programming
IP Phone Manager
Be aware that a default SIP MLT terminal requires a DHCP server to obtain its network information.
As the ITL-2E terminal does not have a display it is not possible to use handset programming in the same
way as the display terminals, there is a specific key press sequence which can be used to default this type
of terminal.
Service Code Factory Default ITL-2E (2 Key DT700)
Under normal circumstances the ITL-2E SIP MLT handsets would be programmed using the web browser.
If the IP address of the terminal is unknown and cannot be discovered by other means (i.e. system
programming, Wireshark etc), the handset may required to be defaulted.
Be aware that a default SIP MLT terminal requires a DHCP server to obtain its network information.
Follow these steps to default the handset: -
Key Press
Hold Conf * *
Name = Auto Config File Name
Data Type = String
Code = 153
Name = Download Protocol
Data Type = Byte
Code = 163
Click OK.
Function
Enter programming mode
Line Key 1 Line Key 2
Green Green
MW Lamp
Off