NEC UNIVERGE SV9100 Manual page 244

244
Operating Procedures
From one MLT to another MLT:
The originating MLT user dials the desired station number in a different office and receives ring
back tone.
Calling party dials 1. A signal tone is transmitted over the K-CCIS network to the called party
speaker.
The called party can press MIC, or press FEATURE and dial 1 (if the MIC LED is not on) to allow
two-way conversation with the calling party.
Service Conditions
General:
The UNIVERGE SV9100 can assign a Feature Access/One Touch Button as a Voice Call key. This
performs the same operation as pressing 1.
Any station in the same system can use Directed Call Pick Up to retrieve the Voice Call over K-
CCIS.
When a Voice Call is sent to a station that is unable to receive voice announcement, RST is
displayed on the originator display.
During Voice Call, the ICM Key is flashing (Red).
Restrictions:
The calling party must wait for at least one ring back before Voice Call is attempted.
After the calling party changes ring back to Voice Call, it cannot be changed back to tone.
Voice Call cannot be set as the initial call across K-CCIS.
Group Call Pick Up is not allowed to retrieve voice calls over K-CCIS.
Single Line terminals can be used to originate a Voice Call Over K-CCIS. However, they are not
allowed to receive a voice call.
Related Feature List
Station-to-Station Calling – K-CCIS
Handsfree Answerback – K-CCIS
Guide to Feature Programming
This guide provides a list of associated Programs that support this feature.
Voice Mail Integration – K-CCIS
Feature Description
This feature allows any station user in the K-CCIS network to use the Voice Mail System (VMS) in another
office in the K-CCIS network.
VM8000 In-Mail voice mail is supported for centralised voice mail in a KTS to KTS network for K-CCIS.
VM8000 In-Mail voice mail is supported for centralised voice mail in a Netlink network.
For more details, refer to the UNIVERGE SV9100 Features and Specifications Manual.