Iple Led Indications - NEC UNIVERGE SV9100 Manual

2.4.2

IPLE LED Indications

GPZ-IPLE LED Indications
LED indications for the GPZ-IPLE Daughter Board are indicated in Table 1 - IPLE Daughter Board LED
Indications on page 4-29.
Each LED is listed with its associated function and LED and Operational status. Refer to Figure 1 - GCD-
CP10 Blade with Daughter Boards Installed on page 4-16 for the location of the LEDs on the blades.
LED
LINK 10
(D103)
LINK 100
(D102)
LINK 1000
(D101)
ACT (D100)
Table 1 - IPLE Daughter Board LED Indications
Table 2 - IPLE Daughter Board LED CN1 Transmit/Receive Data Indications shows the LED indication
when transmitting or receiving data on CN1.
ACT
Link1000
Off
Off
On
On
Flash
Function
10 Base-TX link speed indicator
100 Base-T link speed indicator
1000 Base-T link speed indicator
Link activity or data transmission
and reception
LED
Link100 Link10
Off Flash Flash
On Flash Flash
On Flash Flash
Off Flash Flash
Blinking one by one
LED
Status
Operation Status
On Red 10 Base-TX link up
On Red 100 Base-T link up
On Yellow 1000 Base-T link up
On Green LED lights when link up is
completed. LED flashes
when data is transmitting or
receiving.
Operation Status
Internal Error (Hardware Error)
State of half-duplex transmission (Not
supported) Change HUB etc. to full-duplex
transmission.
The firmware is being updated.
Part 2: VoIP Manual 61