NEC UNIVERGE SV9100 Manual page 120

120
Caller ID Update after Transfer
Caller ID Update after Transfer is designed for use with NEC IP DECT, the operation of this feature cannot
be guaranteed with other Standard SIP Terminals.
It allows the CLI displayed on an IP DECT handset to be updated to show the transferred party's name or
CLI after the call has been transferred.
Prior to this feature the IP DECT display would show the information from the transferor rather than the
transferee.
IP DECT Firmware
Caller ID Update after Transfer is supported from DAP firmware V4910b510.dwl onwards and on any
handset firmware.
Conditions/Comments
Extension name or CLI to name conversion is not supported for this feature, only the extension number
or CLI.
If no CLI is available on the trunk call "Anonymous" is displayed on the IP DECT handset.
Programming
There is no programming required on the SV9100 or on the IP DECT system to activate this feature.
Conference Call by Standard SIP Phone
The SV9100 supports voice conference features of standard SIP extensions and does not use the
conference resources on the system.
The target terminal of this feature is the POLYCOM VVX1500D. If a standard SIP terminal has the same
conference sequence as the VVX1500D , then this may be able to be supported also using this feature.