NEC UNIVERGE SV9100 Manual page 210

210
System Availability
Terminal Type:
All multiline terminals
Required Components
GPZ-IPLE
Operating Procedures
To set or cancel Night Transfer system-wide from an Attendant Position:
Main Office:
1. Press Speaker.
2. Dial Access Code 818.
3. Dial the Night service Code:
1. Day 1 mode
2. Night 1 mode
3. Midnight 1 mode
4. Rest 1 mode
5. Day 2 mode
6. Night 2 mode
7. Midnight 2 mode
8. Rest 2 mode
4. Press Speaker or hang up.
- OR -
1. Press the Night Transfer key on the Attendant Add-On Console.
Remote Office:
No manual operation is required.
Service Conditions
General:
A maximum of 16 remote offices can be controlled by one main office.
If Automatic Day/Night Mode Switching is assigned in the main office, all remote offices change
the mode, if assigned.
If the remote office is to be restricted from overriding the Day/Night Mode setting, the following
Programming Commands should be assigned:
12-01-01 Night Mode Function Setup – Manual Night Service enable
20-07-01 Class of Service Options (Administrator Level) – Manual Night Service enable
When the remote office is in Night Mode (as assigned in the Centralised Day/Night Mode - K-CCIS
feature), normal Night Mode indications are provided.
The Night Mode indication is the first word (Night) on the second row of the multiline terminal LCD.
The LED for any Feature Access key assigned for Night Mode transfer and the Night Mode key on
the Attendant console are On.
If the K-CCIS link is not available due to network trouble, the UNIVERGE SV9100 main office
resends the K-CCIS Day/Night Mode switch command every 16 minutes.
Restrictions:
Centralised Day/Night Mode switching from a main office can send a system-wide K-CCIS Day/
Night mode switch command only. Individual Night Service Groups Mode switching is not
supported.
When an UNIVERGE SV9100 receives the K-CCIS Day/Night Mode switch command from a main
office, the remote office changes all Night Service Groups to the requested mode.