NEC UNIVERGE SV9100 Manual page 185

Resources per system.
Each system in the network must have:
GCD-CP10
GPZ-IPLE
Feature Networking (K-CCIS) license(s):
K-CCIS Easy Edit Programming
Easy Edit – Advanced Items/VoIP/Networking/K-CCIS
K-CCIS Setup
Easy Edit – Advanced Items/VoIP/Networking/K-CCIS/K-CCIS Setup/K-CCIS IP Trunk Assignment
Trunk Type - Set to CCIS
Start Port - Enable the logical starting port number
Number of Ports – Enter the required number of CCIS trunk ports
Easy Edit – Advanced Items/VoIP/Networking/K-CCIS/K-CCIS Setup/K-CCIS IP Setup
IPL IP Address – This is the signalling address of the SV9100's own GPZ-IPLE card
IPL Subnet Mask – This is the subnet mask of the SV9100's own ILP card
Default Gateway – This is the IP address of the default gateway on the SV9100's own network
02)
CCIS Availability – Enable the availability of K-CCIS networking
Server TCP Port – This is the TCP port number used by the server side for K-CCIS
Client TCP Port – This is the TCP port number used by the client side for K-CCIS
Connection Method for DT800/DT700 – This enables peer to peer communication between DT800/DT700
extensions on different K-CCIS nodes
Easy Edit – Advanced Items/VoIP/Networking/K-CCIS/K-CCIS Setup/K-CCIS IPL VoIP Resource IP
Address (PRG84-26)
For an GPZ-IPLE card only one address is required regardless of the number of voip channels licensed.
For the RTP and RTCP ports enter the starting port number for each IP address. Each DSP requires one
RTP port and one RTCP port. Under normal circumstances there is no need to change these settings from
default.
Easy Edit – Advanced Items/VoIP/Networking/K-CCIS/K-CCIS Setup/K-CCIS Trunk Groups (PRG14-05)
Assign a unique trunk group to the K-CCIS trunk ports and set them as Tie Line for the relevant mode of
service
Easy Edit – Advanced Items/VoIP/Networking/K-CCIS/K-CCIS Setup/K-CCIS Local ID (PRG50-02-03)
Assign the Origination Point Code for Route ID 9 for the local SV9100
Easy Edit – Advanced Items/VoIP/Networking/K-CCIS/K-CCIS Setup/K-CCIS Remote ID (PRG50-03)
Set the Destination Point Code and the IP Address of each remote node
Easy Edit – Advanced Items/VoIP/Networking/K-CCIS/K-CCIS Setup/K-CCIS Codec Setup (PRG84-21)
K-CCIS can use various CODECs. A CODEC is a standard for converting an analogue signal to digital.
This conversion process is handled by the DSP (Digital Signal Processors) on the GPZ-IPLE card.
Each CODEC has different voice quality and compression properties. The correct choice of CODEC will be
based on the amount of bandwidth available, the amount of calls required and the voice quality required.
Available Codec's for K-CCIS
· G.711 64Kbps codec MOS 4.4
(PRG10-68-01)
(PRG50-15-04)
Part 2: VoIP Manual
BE114066
(PRG10-68-02)
(PRG10-68-03)
(PRG50-01-01)
(PRG10-12-09)
(PRG10-12-10)
(PRG10-12-
(PRG50-15-02)
(PRG50-15-03)
185