Sip Trunks - Carrier Mode - NEC UNIVERGE SV9100 Manual

Enable VBD on SIP Trunk by using the 'Voice Band Data (VBD)' option in Easy Edit
SIP Networking/Profile x/SIP Profile x - Trunk General Settings/SIP Profile x - CODEC Settings (PRG84-13-
66).
For each VBD device connected to the system set the Terminal Type to SPECIAL using the 'Terminal
Type' (PRG15-03-03)
Type' (PRG15-03-18)
Setup.
2.6.3.1

SIP Trunks - Carrier Mode

SIP Trunks - Carrier Mode
All information about a specific SIP carrier can be found on the relevant 'SIP Certificate of Compatibility'.
The information below gives general information about programming SIP Trunks Carrier Mode.
Up to 6 SIP Carrier configurations can be configured on a single SV9100 system. SIP Profiles 1 - 6 contain
identical programming pages. In the below Easy Edit references they are referred to as either Profile x or
SIP Profile x to remain generic.
SIP Trunk Easy Edit Programming
Easy Edit – Advanced Items/VoIP/Networking/SIP Networking/
Easy Edit – Advanced Items/VoIP/Networking/SIP Networking/SIP IP Trunk Assignment
Trunk Type - Set to SIP
Start Port - Enable the logical starting port number
Number of Ports – Enter the required number of SIP trunk ports
Assign the SIP Profile used to the SIP trunks assigned in Easy Edit
Networking/ SIP Trunk Data Setup (PRG14-18)
Set the trunk Incoming Type as required (usually DID) for each Trunk Port and Mode Number in Easy Edit
Advanced Items/VoIP/SIP Networking/Profile x/SIP Profile x - General Settings/SIP Profile x - Trunk
Incoming Type (PRG22-02)
Carrier Mode IP Address
Easy Edit – Advanced Items/VoIP/SIP Networking/Profile x/SIP Profile x - Carrier Mode (IP Address)
Use this set of commands if the ITSP has provided you with an IP address for their SIP server rather than a
Fully Qualified Domain Name.
System Information Setup
Easy Edit – Advanced Items/VoIP/SIP Networking/Profile x/SIP Profile x - Carrier Mode (IP Address)/ SIP
Profile x - System Information Setup
Domain Assignment – This item tells the system whether an IP address or DNS address will be used to
register to the SIPServer. Set to IP Address.
Server Setup
Easy Edit – Advanced Items/VoIP/SIP Networking/Profile x/SIP Profile x - Carrier Mode (IP Address)/ SIP
Profile x - Server Setup
Outbound Default Proxy and Inbound Default Proxy – These items indicate whether a Proxy Server will be
option and also the Device Type to MODEM using the 'Select Special Terminal
option in Easy Edit– Extensions/Extension/Single Line Telephone SLT/SLT Basic
(PRG10-68-01)
(PRG10-28-05)
Part 2: VoIP Manual
(PRG10-68-02)
(PRG10-68-03)
– Advanced Items/VoIP/SIP
175
- Advanced Items/VoIP/
–