NEC UNIVERGE SV9100 Manual page 39

Example Configuration 2 - New Network with Dynamic Addressing
This shows a typical network configuration using Dynamic IP Addressing, and the UNIVERGE SV9100
Internal DHCP server. In most cases, the customer would use an external DHCP server (for example on a
Windows Server) or static addressing (as illustrated in Example Configuration 1). However, if the
UNIVERGE SV9100 is to be installed on a new network the Network Administrator may want to use the
UNIVERGE SV9100 internal server (this is called inDHCP). In this example, the client PCs get an IP
address, subnet mask, and default gateway from the inDHCP server. The server also uses DHCP, but
should always be given the same IP address (192.168.1.32).
The Network Administrator (or IT Manager) should provide the following:
IP Address (for the GCD-CP10 blade)
IP Addresses (for the GPZ-IPLE)
Subnet Mask
Default Gateway
Range(s) of IP Addresses to assign
List of permanent IP addresses, with corresponding MAC Addresses
A spare switch/hub port
Exa m p le C o n fig u ra tio n 2 - N e w N e two rk with D yn a m ic Ad d re ssin g
Part 2: VoIP Manual 39