Toshiba Strata DK 280 Installation Manual page 256

xxx = PDIU-DI escape sequence (see Subsection ATCO will switch the RPCI-DI back to the API
6.9.6, paragraph 3).
mode.
PC to Printer Test Call Using Manual Dialing (see
Figure 6-36)
0 RPCI or DIU Programming:
4 Program 20: Port 001. LEDs 01, 02, 05, and
17 ON; all other LEDs OFF.
+ Program 20: Port 003. LEDs 01, 04, and 17
ON; all other LEDs OFF.
+ Program 39: Port 001. Data Call (456) and
Data Release (454) buttons should be
provided.
W Using the manufacturer's documentation, make
sure the communication parameters (data speed,
parity, data bits, stop bits, etc.) of the PC COM
port match the printer's serial interface
parameters.
,
+ Default settings for PDIU-DI, S-Registers.
H Make sure the PC is configured to print data from
its serial COM port (the PC COM port connected
to DKT/PDIU-DI or DKT/RPCI-DI port 001). This is
normally accomplished using the DOS MODE
commands.
n
To connect the PC to the printer, press the DKT's
Data Call
button and dial 2 0 3.
+ The CONNECT on the PDIU-DS will be lit.
+ The connection between the PC and the
printer is completed, as shown by the thick
lines above (PDIU-DS 203 is in the
communication mode).
+ If busy tone is sent to the DKT, the connection
is not complete; press
Data Release
and try
Step 4 again.
Note:
If using an RPCI-DI, it may be necessary to
switch the RPCI from the API mode to the
Data Communications Mode before
proceeding with Step 3. To place the RPCI
into the data communications mode from the
PC keyboard: Set NUJII Lock to ON and type
240
while holding the
Alt
key down (this is
HEX f0). If in the data communication mode
n Operate the PC to print data as required.
W To terminate the call, press the DKT's
Data
Release
button.
RS-232
RS-232
STRATA DK280
I 1
)I
DIGITAL
: (PORT 001) yl I
I I
DK0338
I
Figure 6-36
DK280 PC to Printer Test Call Using Manual Dialing
6-56
January
1996