Toshiba Strata DK 280 Installation Manual page 99

Instructions for floor mounting
1. Mount the DK280 base cabinet on Floor Mount Fixtures (RFMF) per Figure 3-14.
2. Position the base cabinet at the selected installation location.
3. Using a marking pen or pencil, mark the floor where holes will be drilled.
4. Move the base cabinet prior to drilling.
Note: Cover the base cabinet with a suitable drop cloth to prevent contamination of power
equipment by dust created during drilling.
5. Drill holes through tile to accept 3/8-inch threaded rod.
6. After the tiles have been drilled, insert threaded rod through the holes in the tile and mark the
concrete floor directly beneath the holes in the tiles.
7. Remove the tiles. Using a hammer drill, drill holes in the concrete to accept 3/8-inch bolt anchors.
8. Install the bolt anchors, with plugs, in the drilled holes.
Using the driving tool and a hammer, drive each bolt anchor into the floor.
9.
10. Screw threaded rods into each bolt anchor.
11. Install a hex nut, lockwasher, and flat washer on each threaded rod. Screw the nuts down far
enough to allow floor tiles to be replaced over the threaded rods.
12. Replace tiles, over threaded rods, in their original positions on the floor.
13. Reach under the tiles, and screw the hex nuts upward until the flat washers are touching the
bottom of the tile.
14. Using a hack saw, cut the threaded rods at a height of approximately 1.5 inches above the
floor tile.
15. Move the base cabinet into position over the threaded rods.
16. Secure the base cabinet to the floor using flat washers, lockwasher, and hex nuts on each
threaded rod as shown in Figure
CABINET
RFMF
(Floor mount
fixture)
Figure 3-1 8
-
Floor Mount Installation
January
1996
a
on
3-18.
Computer Room Floor
computer room floor.
3-25