Toshiba Strata DK 280 Installation Manual page 413

2. Modified Digits Table (1 - 12):
Refer to
Programs 55-0, 55-1 and 55-2. The system
handles line groups differently, according to which
modified digits table was assigned in Program 54.
Program 55 Series- LCR Modified Digits Tables
This program defines 6 or 12 modified digits tables for
LCR call handling (see Program 55 record sheet
notes.). Each modified digits table assigns editing
steps that include:
n
Deleting a pre-defined quantity of digits from the
front of the number dialed (Program 55-O).
n Adding a pre-defined number to the front of the
number dialed (Program 55-l).
n
Adding a pre-defined number to the end of the
number dialed (Program 55-2).
The purpose of this program is to define call handling
so the route definition used by LCR is invisible to the
station user. The station user handles all calls the
same way. The goal is for LCR to remember the
dialing peculiarities of each call route, so the user
doesn't need to know.
Program 55-O-LCR Modified Digits-Delete
Enter the quantity of digits that should be deleted from
the front of the number dialed for each of the Table
Numbers in the Delete Digits Table. The maximum
number is ten. Always make the entry two digits.
Program 55-l-LCR Modified Digits-Add to Front
of Dialed Number
Enter the digits that must be added to the front of the
number dialed in the Add Digits Table. The maximum
digits is 22, including pauses.
n
Length of pause can be indicated by using codes
(Pl - P8) specified in the Pause Entry Reference
Table. Each pause takes two digits of memory
space.
n
Try to allow for the longest wait, e.g., make the
pause longer, rather than shorter, to
accommodate the length of time a carrier may
need to access the service tones, etc.
Program
55-2 -LCR Modified Digits-Add
to End
of Dialed Number
Enter the digits that must be added to the end of the
number dialed in the Add Digits Table. The maximum
digits is 22, including pauses.
n
Length of pause can be indicated by using codes
(Pl - P8) specified in the Pause Entry Reference
Table. Each pause takes two digits of memory
space.
n
Try to allow for the longest wait, e.g., make the
pause longer, rather than shorter, to
accommodate the length of time a carrier may
need to access the service tones, etc.
Program 56-LCR Station Group Assignments
The purpose of this program. is to assign all defined
station ports to one of four or eight LCR Station
Groups (see Program 56, record sheet notes).
n Station groups are completely independent of one
another. Therefore, each station group must be
defined separately.
4 Software does not automatically assign the
highest, all-inclusive routing priority to Class 1
stations, making all routes available to Class 2 - 8
stations available to Class 1 as well.
n
Instead, stations are assigned (partitioned) to
independent groups. Flexible assignment of
routing definitions to groups is allowed, with no
one group's definition affecting another's Eadh
group's route definitions are specified to activate
separately according to the time schedules set by
Program 53. Enter the station group number next
to the port number.
January 1996
9-53