Toshiba Strata DK 280 Installation Manual page 682

Table 13-6
Program 90 - Initializing Programs 00 - *99
Step
Action
Display/Printout
1 Enter the Program Mode
>MODE PROG
At the >MODE prompt type PROG, press Enter.
2 Enter Program Number 90 P 90
PreSSEnter.
P90
3 To Initialize All Programs
P90 00*02
l.Typeo 0 * 0 2.
2. Proceed with Steps 4 - 8.
3. Return to Step 3 and type Programs 0 4 *
* 9 9.
4. Proceed with Steps 4 - 8 again.
IMPORTANT!
Do not initialize Program 03 with this program when
programming off-site. Program 03 must be initialized on-site.
Note:
Single programs can be initialized by entering a single program
number plus #. Group numbers are separated by an *.
4 Type button/LED number 0 1.
P90 00*02 01 N
5 Change LED 01 to "ON" by typing Y. P90 00*02 01 N Y
6
PreSS Spacebar.
P90 00*02 01N Y
02 N
7
Change LED 02 to "ON" by typing Y.
P90 00*02 01 N Y
02 N Y
8 PreSSEnter. P90 00*02 01 N Y
Initialization complete.
Note:
P90
02 N Y
If program data is not entered correctly, then
Enter
will
not respond. To retry, press
Delete+Enter.
9
Exit Program 90 P90 ##
Type # # and then press Enter.
P
IO
Enter Program 77
P77
Type 7 7 and then press Enter.
11
Type I I 4.
P77 1 14 N
Type Y and then press Enter.
P77 1 14 N Y
P77
12 To Exit this Program:
Type # # and then press Enter.
nK"d
IMPORTANT !
Toshiba recommends
initializing Program 77-l remotely. Also if program 01 or 02 is initialized all calls
will drop, including the remote
maintenance CO line. If all programs are initialized, the "RMDS or IMDU
enabled" has also been turned
off in Program 77-1, LED 14. If using the RMDS or IMDU for remote
programming, go into Program 77-l and turn
Button/LED 14 on as shown in Steps 9, IO, and Il. If this is
not completed, remote programming must be reactivated locally from the digital or electronic telephone
programming station.
January
1996
13-19