Toshiba Strata DK 280 Installation Manual page 379

69. Selected stations must dial the the following
sequence to change the codes:
Intercom
or [PDN] + # 6 5 9 + 0 0 0 - 2 9 9
+ Verified Account Code
+ Redial
Note:
Electronic telephones that do not have the
REDIAL
button, can use the # button
instead.
Verified Account Code, LED 14-If this feature
is selected, all Account Codes (Forced or
Voluntary) dialed by the station user (or DISA line
user) will be verified per Account Codes set in
Program 69. If the station user fails to dial one of
these specific Verified Account Codes, the call
cannot be executed (Forced), or the Account
Code will not be validated for the SMDR call report
(Voluntary).
Standard Telephone Hookflash Anti-bounce
Guard, LED 12-This feature should be turned on
for all PSTU/RSTU/RSTlQ/RDSU/PESU standard
telephone ports that have standard telephones
(with/without message lamps) connected to them
to prevent false ring signals. With this option on, a
CO line connected to a standard telephone will be
disconnected if the standard telephone user
hookflashes and then hangs up; if this option is
off, the CO line will recall the standard telephone.
Dial Pulse (Dual-tone Multi-frequency (DTMF)
Off), LED 11-If any device, DID or tie line station
port does not require the RRCS for DTMF
decoding, it should be programmed for Dial Pulse
(LED 11, ON). When the device goes off-hook or
the DID or tie line is seized for an incoming call,
the RRCS will not be accessed, thereby reducing
unnecessary traffic to the RRCS.
Change DISA Security Code, LED lo--This
allows a selected station to change the DISA
security code by dialing
Intercom
or [PDN] +
# 6 5 8. + Security Code + Redial.
Change Toll Restriction (TR) Override Code,
LED OO-Two Toll Restriction Override codes are
available in the system. When one of these codes
is dialed from any station, all Toll Restriction is
bypassed. These codes can be changed only by
stations assigned in this program by pressing
Intercom
or [PDN] + # 6 5 4 for Code 1, or by
pressing
Intercom
or [PDN] + # 6 5 5 for Code
2;
press
Redial
to store.
n
n
n
n
a
Forced Account Code, LED 08-If this feature is
selected, a station or Direct Inward System
Access (DISA) CO line user using a line with a
Forced Account requirement (Program 15-7) must
enter an Account Code before the outgoing
CO/tie/DID line call can be completed. If Forced
Account Codes should be verified, turn on LED 14
in Program 30. The digit length of Forced Account
Codes is determined in Program 60-4.
Off-hook Call Announce (OCA) Automatic, LED
07-A busy digital or electronic telephone can
receive a second voice communication over the
telephone Handset/Headset or over the telephone
Speaker. (See Program 31--LED 03, 13 and 14.)
If a calling station does not have the automatic
function set in this program, the calling station
user must dial extra digits of 21 after hearing busy
tone or 12 after hearing ringback tone in order to
gain access to OCA. Initialized data makes all
stations automatic for OCA. "OCA Automatic" only
works on systems with Voice First Signaling
(Program 10-l or 10-2, LED 01, OFF)
Automatic Busy Redial (ABR) Access, LED
06-The ABR feature can be enabled or denied
for each station. The system will select the last
line in the originating line group each time ABR is
initiated (also see Program 10-l). If the ABR
access feature is not enabled here, the ABR soft
key will not appear on LCD telephones. Note that
ABR is not functional for DID or tie line calls.
ABR overrides Program 4 1. Program 4 I is
normally used with Least Cost Routing (LCR).
Speed Dial, LED 05-A station may be denied
the use of Speed Dial (Station and System) with
this program. Initialized data allows Speed Dial for
every port.
Microphone Button On at Start of Call, LED
03-The microphone, as well as the
Mic
button
LED, can be selected to be on or off at the start of
a call if the Push On/Push Off mode (see Mic
Button Lock, LED 02) is chosen.
Note:
When receiving intercom or internal DN calls,
the flexible Microphone Cut-off MC0 button
(Program 39) can control the microphone to
prevent room monitoring and Handsfree
Answerback.
I
January 1996
9-l 9