Toshiba Strata DK 280 Installation Manual page 451

Program 15 -
Ground/Loop/Tie/DID Line Options
SELECT = Program Code 1
Press: Fl to advance or F] to go back'
Specify CO line by setting LEDs as defined by the
table below. All LEDs with an "X" should be lit when
Copy this page for more lines.
finished. See Note 2 to turn line ranges ON/OFF.
Check off the line range covered by this table.
Range 001 - 020 _ 021 - 040 _
041 - 060 _ 061 - 080 _ 081 - 100 _
101 - 120 _ 121 - 140 _ 141 - 144 _
Progran
Code
0
CPC on AR VM Calls3 and
voice calls
1
2
CO/DID/Tie Line Signal5
CO/DID/Tie Dial Pulse Rate
(Pulse per sec.)
__-
3
AR Hold3c6
4
AR Timing3
----
5
Tandem CO Line Connection
with Station Dropout4
7
Forced Account Code
8
Operation After Flash
Program
Notes:
I
LED Status
ON OFF
01'02 03 04 05
06
07
08 09.10
11
12 13 14 15
16 17
18 19 '20' LED
Detect Ignore
_.-~__ I_-__ -__ ___--
______
DP DTMF
20
PPS 10 PPS
____
Detect
Ignore
~.___
RRCS after flash
-.__
1
-.___-..__ --I_
--.--
1
1 2
,
1. To advance the CO line range, press the Scroll button beneath the LCD. Press the Page button for a lower range.
2. To turn all CO LEDs on or offj after the Program code is entered, press the VolA (all LEDs on) or VOW (all LEDs off), To check a
particular CO line, after the Program code is entered, press Mode and enter the CO line number, then use the # key to display and
advance.
3. The Automatic Release (AR) signal is called Calling Party Control (CPC) or Supervised Loop Control. This signal consists of.a momentary
open of the loop start CO line provided by some Central Office (CO)-the duration of the
open
depends on the CO. If
a CO line is programmed (Programs 15-O and 15-3) to detect the AR signal, the DK system will drop the line when the CO sends the
signal (typical/y 1 - 75 seconds after the outside party hangs up). The system will send D Tone to voice mail (VM) ports to drop the ports
when AR is detected. The Strata DK system will disconnect a loop start CO line voice call anytime that the AR signal is detected and the
CO line has Programs 15-O and 15-3 enabled. "CO LINE HANG UP" will display on the station's LCD when this happens.
4. (Tandem CO line) must be equipped for al/ CO lines that must provide two-CO line conference, DISA, CF-External, or DNIS External
Telephone Network routing.
5. See Program 30, LED 11, for tie/DID Dial Pulse operation.
6. If loop start lines are programmed to detect the AR-Hold signal, they will not remain on the attendant console loop keys when the
attendant console sets up trunk-to-trunk connection. If programmed to ignore AR-/-/o/d, they will remain on the attendant console Hold
loop keys. Enable AR-Hold detect on loop start lines only after testing that the CO sends the AR-Hold signal.
General Note:
,
Initialized data is all LEDs OFF.
January 1996 1 o-35