Toshiba Strata DK 280 Installation Manual page 454

Program 17 -
DID/Tie Line Options
Enter Line No. that will be DID or Tie line.2
To enter Line Range: nnnR[nnn
Low Line
L',i@ Line
Line Numbers?j
rT7
L Light LEDs Ol- 08
as noted below.
,
LED/ Button X LED ON
LED OFF
20
19
18
17
16
15 I I
I
14
10
09
08
DID/tie line DTMF digits with * tones5 DID/tie DTMF digits without + tones5
07
06
05
DID/tie line receives ANI DID/tie line does not receive ANI
(Prog 71 and 72) (DID Prog *09 and tie Prog *04)
Telephone LCD priority is ANl4 Telephone LCD priority is DNIS4
DID/tie line routes per DNIS assignments:
(Prog 71 and 72)3
DID/tie line routes per Non-DNIS assignments:
(DID Prog k09 and tie Prog 04); or for ANI only lines"
04
DID/tie no second dial tone DID/tie second dial tone
03 DID line Auto Camp-on busy
DID line no Camp-on busy
02
Wink start for tie or DID' Immediate start for tie or DID'
01
Page and Voice Announce on incoming tie line
Page access for tie/DID DNIS lines2
No Page and Voice Announce on incoming tie line
No Page for tie/DID DNIS Lines2
DKOll
Notes:
1.
2.
I
3.
I
4.
5.
6.
LED 03/04 applies to REMU, PEMU, RDDU and RDTU DlDs and tie lines, LED 02 applies to PEMU, REMU, and RDDU on/y; see
Program S-4 l-2
for RDTU
wink/immediate assignments.
a. In DK280 Release 1 and 2, LED 01 applies to tie lines only. DID lines are not allowed Page or Voice Announce per FCC
regulations.
6. If the DID lines are on a private network, then in DK280 Release 3, LED 01 may be on to allow Page access on fie and DID lines
programmed with DNIS assignments in Program 71 (Code #039). For public telephone networks, tie, DID, or DNIS lines must
a/ways be restricted (LED 01 OFF) from Page and Handsfree Answerback per FCC regulations.
N normal (non-AN/ and/or DNIS), tie/DID lines should use Program 71 and 72 assignments instead of Program 04 (tie) and Program
M9 (DID) assignments, turn LED 05 ON and LEDs 06, 07, and 08 OFF. Turn LED 05 off for ANI only lines which should route per
Programs 71 and 72. Turn LED 05 ON for DNlS only or ANI with DNIS lines.
Telephone LCDs can display ANI or DNIS information as a priority when tie/DID lines receive both A NI and DNIS digits.
DID/tie lines wifh ANI/DNIS digit format includes * tone with digits; DID/tie lines with normal digit format does not include * tone with
digits. Most all ANI/DNIS carrier providers include * tones with digitti (LED 08 ON), except, as of this writing, when Sprint provides
DNlS without AN/, it does not include * 's with digits (LED 08 OFF).
Copy one record sheet for each group of tie/DID lines that have different Program 17parameters.
Genera/ Notes:
.
Each REMU, PEMU or RDDU PC6 reduces the station port capacity by four station ports, each RDTU tie/DID line channel reduces the
system's station port capacity by one port. .
,
.
Always install fie or DID line PCBs in slot numbers that are higher than station PC6 slot numbers (see Chapter l-Configuration).
.
Initialized data LED 0 l/O2 OFF, LED 03/04 ON.
.
Incoming tie line calls will camp-on only if Program 71 assignments are used.
5
10-38
February 1996