Outward Disa Calls; Direct Station Selection Buttons (Hotline); Door Lock - Toshiba Strata DK 280 Installation Manual

To Make an Outgoing Call
with DISA:
1. From outside the
system, call the DISA
CO line telephone
number:
2. Ltsten for the ringback
tone signal, then listen
for dial tone.
3. Dial a CO line or line
group access code.
4. If a DISA security code
is required, dial the
code, then listen for CC
dial tone
-or-
if a DISA security code
is not required, you
should hear CO dial
tone.
5. Dial a telephone
number.
outward DISA Calls
See the System Administrator for this number
Try again if you hear busy tone
Dial tone will be present for 10 seconds to allow direct dialing of a Directory
Number or CO line access code. If a number is not dialed, the system
automatically causes the DISA CO line to ring at telephones as a normal
incoming call. Then, if the call is not answered within 15 seconds after the
ringing starts, it will disconnect.
See Appendix A-Table l-CO Line Access Codes.
If required, see the System Administrator for this number. If the correct code is
not entered, the call will be disconnected.
Direct Station Selection Buttons (Hotline)
This optional feature allows you to connect directly to another station Primary
Directory Number by pressing a Direct Station Selection [DSS] button. The LED
of the button shows the status (idle/busy) of the station. If connected to a CO
line, pressing this button will put the outside party on hold. Transfer the call as
you would normally, by voice announcing or camping on by hanging up or by
pressing the RLS/ANS button.
The station could be busy on its Primary DN, Secondary DN, a Phantom DN, a
CO line or in Do Not Disturb mode if the DSS LED is lit. If a station is idle but
other stations are using all of the station's [PDN] buttons, the station [DSS]
button will light busy (red).
Door Lock
Your telephone may have an DKLK button(s), which will unlock a door lock
when pressed.
Door Lock Button Locaiion
Unlock Door 0
Unlock Door 1
Unlock Door 2
Unlock Door 3
Unlock Door 4
The door lock will unlock for three or six seconds when you press the button,
depending on system programming. The Unlock Door LED will turn on for
however long the door is unlocked.
A timer tone that is audible to both parties will sound approximately (4, 10, or 20)
minutes after the call was made depending on system Programming. Dial 0 to
reset the timer each time the tone sounds for an additional (4, 10, or 20) minutes.
If you do not dial 0, the call will disconnect approximately one minute after the
tone.
52
53