Toshiba Strata DK 280 Installation Manual page 417

System Record Sheets
Initialization Program 91-9 -
System Initialization
Repeat a second time after LEDs 01,03,05,07, and 09 extinguish
L Enter programming mode.
(Do not press Intercom or
Directory Number [DN]
button.)
L
Press Buttons 01, 03, 05, 07, and 09,
LEDs 01, 03, 05, 07,09, must be lit.
( LCD Displays: SYSTEM
INITIALIZATION
General Notes:
9 Run this program for all new installations - but not while system is in service.
l
This program will run Program 03 and assigns codes to all PCBs (except options)
installed. This program will erase all Program 03 option codes for piggyback PCBs, DSS
'
consoles, WCS, etc, except the RCOS PCB Code (17). Program 03 should be
run (after Program 91-9 is run) for PCBs which have options, such as Dual-tone Multi-
frequency Receivers (RRCS), DSS consoles, etc.
l
Program 9 l-9 will also bring back logical and physical ports to their initialized settings.
l
If entering a customer database into RCTU memory before other system PCBs
(stations, lines, options) are installed, it will be necessary to run Program 03 after
Program 97-9 to identify which option PCBs (e.g., RRCS, etc.) are installed in each
cabinet slot.
l
Running Program 91-9 automatically runs Programs 90, 91- 1, and 92.
l
for Release 3 and above, after running this program go to Part 2 of of Program 00 and
run RAM test before proceeding any further.
CAUTION !
This program MTlALlZES all programs (00 - *99) including
01, 02, 03, 90, 91- I, 92. All calls will be dropped if this program
is run while the system is in service.
I
January 1996
1 o-1