Toshiba Strata DK 280 Installation Manual page 773

2. Press SCRL to view
the saved information
on the LCD display.
(:::::,::,:'j
W Press # to delete
information on the
LCD display.
W Press + to go back
to previous LCD
screen.
3. Press WAD.
To Use Station-to-Station
Message Waiting:
1. Lift the handset or
press a [DN] to receive
internal dial tone.
2. Dial the desired station
number.
3. The calling station user
presses the NMVFI.
(or7) to set the Msg
LED on the called
station.
If your telephone is equipped with a LCAD (Lost Call Auto Dial) button, you may
auto dial a saved number by periorming any of the following:
n Enter Class/AN1 Information display MODE + 6 2, and choose the number
or name of the lost caller you want to contact.
W Press PL2, and then LCAD.
n Press a [DN] button, enter the appropriate CO or LCR access code'. then
press LCAD.
W Press Cff, then press LCAD.
Note:
1. The AN//Caller ID received telephone numbers always include area
codes on local calls BS well as tong distance calls. The DK280
system wi// always auto dial the digit "1" before the saved, outgoing
telephone number.
2. If your telephone requires an account code be entered before dialing
outside telephone numbers, enter the account code after access
LCR or a CO line, then press the LCAD button.
Station-to-Station Message Waiting
If there is no answer (or if the telephone is busy or DND), press the MW/FL
button (or 7). This causes the MW/FL LED on the called station to flash. The
called station's LCD displays the calling station's number. When the returned call
is answered, the flashing MWIFL LED will turn off.
The [DNs] after SENT are the [DNs] which received your message waiting
indication signal, if you sst a message waiting indication signal.
26
To answer the Msg LED
indication from ths
called station, press the
flashing MWlFL
button.
To clear the Msg LED
that you set on some
other telephone's [DN]
from the [DN] that sent
the Message Waiting
signal, press the [DN]
button, dial the
Directory Number that
you set the MW signal
on and press MWlFL
twice (or 7 7).
To clear the Msg LED
from the [DN] that
received the Message
Waiting signal, press
the[DN]+# 4 0 9.
Note:
Up to five message waiting displays may be stored on the LCD per each
[DN] owned by the telephone (IPDNs] and [PhDNs]). The station [DN]
in the display wi// be called when the flashing MW/FL or [PhDNMIW] is
pressed. To rotate the station numbers, press SCRL. The fourth
message for each [DN] is reserved for the Message Center. The ""+"sig"
on the LCD indicates that more than one message waiting signal was
sent to your telephone.
In this example, [ZOl] received a message signal from [SOO].
This clears all messages recorded to this station.
Voice Mail (VM)
Whenever your station is call forwarded to voice mail, certain digits will
automatically be sent to the voice mail unit to direct the call to your mailbox.
These codes require storage one time since they remain in memory until
changed. They do not have to be stored each time you Call Forward your
telephone. Your Primary Directory Number [PDN] and up to four Phantom
Directory Numbers [PhDNs] can be independently call forwarded to unique or to
the same voice mail boxes from your telephone.
Telephones must be programmed as the owners of a [PhDN] to be able to call
forward the [PhDN] to a voice mail box number.
27