Toshiba Strata DK 280 Installation Manual page 487

Program 38 -
Digital and Electronic Telephone Keystrip Type (continued) .
The electronic telephone keystrip code assignments are as follows:
1 MW/FL3 1 1 t
CO9 1 MW/FL3 1
I
CO9 1' MW/FL3
1 1
SD 10
1 MW/FL3 1
CO8 1 DND
INT or [PDN]*l co10
I
I I I
CO8 DND CO8
DND
I
I
C04 1 SD11 1 1 CO4 1
SD15
Code 2 1 Code 31 (Default)
Code 32 Code 33
1 O-button
ZO-button (A) ZO-button (B) ZO-button (C)
The programming keystrips are as follows:
ZOOO-series Digital Telephone
16, 36, 56, 76 17,37,57,77 18,38,58,78 19,39,59,79
96,116,136
20,40,60,80
97,117,137 98,118,138
99,119,139
100,120,140
11,31,51,71 12,32, 52,72 13,33,53,73
14,34,54,74
91,111,131
15,35, 55,75
92112,132
93,113,133 94,114,134 95,115,135
06,26,46,66 07,27,47,67 08,28,48,68 09,29,49,69
86,106,126
10,30,50,70
87,107,127
88,108,128 89,109,129
90,110,130
01,21,41,61 02,22,42, 62 03,23,43,63
04,24,44,64
81,101,121,141 82,102,122,142 83,103,123,143 84,104,124,144
05,25,45,;5
85,105,125
1 OOO-series Digital Telephone
DK0222
Notes:
1. This button is initialized as SD1 0 with RCTUA since there are only 16 CO
lines.
2. DK280 Release 1 and 2 Intercom (INT) buttons are rep/aced by
Primary Directory Number
[PDN]
buttons in DK280 Release 3 software.
3. If changing PEKU PCBs (electronic telephone) to PDKU PCBs (digital
telephone), or vice versa, always check that the Speed Dial or IWWFL
button is set appropriately in Program 39.
General Note:
l
Button numbers 01 - 144 on electronic telephones (6000, 6500 series,
etc) are in the same position as shown on the ?OOO-series digital
telephone programming keystrip.
January 1996 1 n-71