Toshiba Strata DK 280 Installation Manual page 566

I
Program *81, *84,
and
*87 -
Ground/Loop Start/CO line to Directory
Number Button LED Flash Assignments -
(001 - 072)(R3)
Enter:
fTJ = Day Ring
1,4, or 7
q
= Day 2 Ring
q
= Night Ring
the [DN] LED that should flash:
Primary [DN]: Port 000 - 239 (Prg 04)
Phantom [DN]: Port 500 - 739 (Prg *04)
Button 01 enters blank data.
033 033
034 034
035 035
036 036
CO LINE DAY RING DN DAY 2 RING
NIGHT RING
NUMBER (*al) DN (*64) DN (*87)
037
I I I
063
064
065
066
067
066
069
070
I
I I I
I
071 1
I I
,
072 1
Notes:
1. To enter a CO line range, enter:
nr~-wn--~r~ in place of : r~rr-+q
--
Low CO line--l I- High CO line
General Notes:
* Initialized data: no [DNs] assigned to ring.
* If a CO line is assigned to flash a Directory Number [DN] in this program, the assigned [DN] LED will f/ash as 1 Hz rate when the CO line
rings into the DK280; use Program 81 - 89 to assign the telephones equipped with the
[DN]
to ring as required.
IMPORTANT !
if CO lines direct ring VM ports in Program 81 - 89, the data in Programs j81, *84, and ~~87 must be blank.
* The CO line that is assigned to flash a [DN] in Program *81, e4, and *87 should also be assigned to ring the telephones on which the
[DN] appears. CO lines are assigned to ring telephones using Program 8 1 - 89.
.
* If the CO line button is programmed (Program 39) to appear on a telephone, do not assign a [DN] to f/ash on that
telephone with Program
+I, *84, and *87.
l
See CO line/[DN] button LED control logic diagrams that follow these record sheets.
1
O-1 52 February 1996