Set-Up; Local Operation; Remote Terminal Operation; Requirements - Toshiba Strata DK 280 Installation Manual

5. Set the terminal parameters to:
Word length: 7 bits
Stop bits: 1
Parity: Even
13.5.3 local Operation
Use the procedure below to establish communications
between the local terminal and the PIOU(S) so that
programming may be accomplished via the terminal.
,
1. Set-up the terminal as described in Paragraph
13.5.2.
2. Set the terminal to on-line.
3. Set Caps Lock on.
4. Press Enter.
+ The system responds, and the terminal
displays:
DK CONNECT
> CODE
5. Type the four-digit security code, and press
Enter.
+ The system responds, and the terminal
displays:
OK
MODE
Note:
The security code can be entered any time
the CODE prompt appears.
6. Go to Section 13.7-Selecting a Mode.
13.6 Remote Terminal Operation
13.6.1 Requirements
Terminal: The terminal must interface with an
asynchronous modem, communicate in ASCII code at
300 - 9600 bps (depending on the TTY port used),
have a standard typewriter-type keyboard, and display
'data via a CRT display or printer. A personal computer
capable of emulating the described terminal may also
be used (see Figures 13-2, 13-3, or 13-4 and
Paragraph 13-l 5).
Modem: The modem must be full-duplex
asynchronous, operate at 300 - 2400 bps, and have
an RS-232 interface to connect with a terminal or PC
(as described in the previous paragraph). It must
interface with the public telephone network and be
compatible with Bell 103 or 212 modem specifications.
13.6.2 Set-up
Refer to Figures 13-2, 13-3, or 13-4 and verify that the
remote terminal is connected and set-up as follows:
1.
2.
3.
4.
5.
Connect the terminal and modem together with
the RS-232 cable.
Note:
If a personal computer is being used, connect
the cable to the serial "COM" port.
Connect the modem line input to a CO/PBX line
for access to the public telephone network.
Set the terminal and modem bps rate to match the
PIOU(S), RSSU, RSIU, or RSIS setting.
Set the terminal and modem for "Full Duplex"
operation.
Set the terminal parameters to:
Word length: 7 bits
Stop bits: 1
Parity: Even
13.6.3 Remote Operation
Automatic connection via ringing assignments: To
establish communication between the remote terminal
and the RMDS or IMDU, call the number of the system
CO line assigned to ring the RMDS or IMDU via the
remote terminal/modem set-up:
1. Observe the following:
+ When the CO line rings-in, it will connect to
the RMDS or IMDU and the RMDS or IMDU
will respond by returning modem tone to the
remote modem.
+ The remote modem will return modem tone to
the RMDS or IMDU and communication will
be established.
+ When communication is established, the
terminal will display: CONNECTED or
COMMUNICATIONS (see Note in the
following section).
2. To continue, enter the security code per the
following section.