Local Terminal Operation; Requirements - Toshiba Strata DK 280 Installation Manual

Note:
The security codes are initialized as "0000".
These codes can also be changed via a local
or remote terminal.
13.4.5 IMDU
and
RMDS On-site Testing
From any working station, test the functioning of the
RMDS or IMDU.
1. Press an Intercom or [DN] button. Receive
intercom dial tone.
2. Dial # 1 9. Receive modem tone from the IMDU
or RMDS after a two-second delay.
Notes:
If you do not receive modem tone:
1. Check to see that the SW3 switch on the
PIOU/PIOUS is set to "MODEM". See
Chapter 4-Printed Circuit Boards.
2. Check Program 77-1, LED 14 for
IMDU/RMDS assignment.
3. Check Program 03 for the correct RSIU or
PIOU/PIOUS/RSSU slot assignment.
4. Check Program 76 for RSIU or RSIS TTY
assignment.
3. Press the Spkr button to release.
4. Make an incoming call over each CO line that is
programmed to ring the RMDS or IMDU (station
#19).
Receive modem tone from the RMDS or IMDU
after a two-second delay with each call.
Note:
This test checks basic programming and
RMDS or IMDU operation, and should be
completed before continuing with Remote
Administration and Maintenance installation.
5. If a terminal is to be used on-site, refer to
Paragraph 13-5. For off-site programming refer to
Paragraph 13-6.
Conventions for Local
and
Remote
Terminal Operation
Delete =
the Delete key
Enter =
the Enter or Return key
Spacebar =
the space bar
J
13.5 Local Terminal ,Operation
13.5.1 Requirements
The KSU must have an RSIU, RSIS, RSSU, PIOU, or
PIOUS PC6 installed per Chapter 4-Printed Circuit
Boards. Refer to Paragraph 13-4 and Figure 13-5 for
terminal installation details.
The local terminal must have an EIA RS-232 interface,
communicate in ASCII code (seven-bit word
length/one stop bit/even parity) at 300 - 9600 bps,
have a standard typewriter-type keyboard, and display
data via a CRT display or printer. A personal computer
capable of emulating the described terminal may also
be used (see Figure 13-5).
Operating the terminals, local or remote, is identi?al.
The only difference is the physical connection and the
method used to establish initial communications.
13.5.2 Set-up
Refer to Figure 13-2 and verify that the local terminal
is connected and set up as follows:
1. Connect the RS-232 cable to the terminal
connector and the RSIU, RSIS, RSSU, or PIOU(S)
TTY connector (Figure 13-5).
Note:
If a personal computer is being used, connect
the cable to the serial "COM" port.
2. Set the terminal baud rate to match the PIOU or
PIOUS SW2 setting (300 or 1200 bps with
PIOU/PIOUS/RSSU or j200-9600 bps with RSIU
or RSIS).
3. Set the terminal for "Full Duplex" operation.
4. Set the keyboard for
Caps Lock
on.