Connector Pin-Out On The Pz-Bs10/Pz-Bs11; Install The Pz-Bs10 Expansion Base Blade In The Chs2U Controlling Chassis; Table 3-1 Pz-Bs10/Pz-Bs11 Connector Pin-Out - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
System Hardware Manual
The PZ-BS10 provides:
Communication Processor Interface for data handling through

Communication Channel (24 slots maximum)
64 Channels for Telephony Resource (e.g., DTMF Tone

Receiver, Call Progress Tone Detector, MFC Tone Receiver,
Caller ID Receiver, Caller ID Signal Sender)
DSP Resource Management

2.3.2.1

Connector Pin-Out on the PZ-BS10/PZ-BS11

Table 3-1 PZ-BS10/PZ-BS11 Connector Pin-Out

PZ-BS10 – CN2, CN3, CN 4
2.3.2.2 Install the PZ-BS10 Expansion Base Blade in the CHS2U
Controlling Chassis
1. Ensure the chassis is powered down.
2. Locate the door positioned on the left end
(expansion bay) of the Controlling Chassis.
RJ-61 Cable Connector
PZ-BS11 – CN3
Pin No.
1
2
3
4
5
6
7
8
Do not remove or install this blade with
the power on.
Issue 9.0
Connection
HW_UP (+)
HW_UP (-)
HW_DWN (+)
FS (+)
FS (-)
HW_DWN (-)
CK8M (+)
CK8M (-)
3 - 5