Send A Startup (Remote) Signal To The Recorder; Figure 7-30 Ada-L Solder Points; Figure 7-31 Ada-L Cable Opening - NEC Univerge SV8100 System Hardware Manual

Issue 9.0
7 - 38
10.3.3.3

Send a Startup (REMOTE) Signal to the Recorder

1. Using a Phillips screwdriver, remove the screw from
the ADA-L UNIT. Solder the cable to the T1 and T2
contacts on the internal board (refer to
ADA-L Solder
2. Run the cable out of the opening of the ADA-L UNIT
(refer to
Points).
Ensure solder does not adhere

to surrounding parts.
Remove any solder waste from

the board.

Figure 7-30 ADA-L Solder Points

Figure 7-31 ADA-L Cable
DSW 4 must be set to ON.

This function is not supported

on some recorders.

Figure 7-31 ADA-L Cable Opening

Installing SV8100 Optional Equipment
UNIVERGE SV8100
Figure 7-30
Opening).