Figure 5-84 Serial Cable Installed - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
System Hardware Manual
10. Open the small door covering the side option
connectors by pulling the cover latch toward you
(refer to Figure 5-84 Serial Cable
DT700 only).
11. Connect the cable from the DCL-60-1 CONSOLE to
the Side Option Connector on the multiline terminal
and close the cover (ITL, DT700 only).

Figure 5-84 Serial Cable Installed

12. Set the tilt leg on the multiline terminal to the
desired height.
13. Set the height of the tilt leg on the DCL-60-1
CONSOLE to match the tilt leg on the multiline
terminal.
14. Attach the side panel to the side of the DCL-60-1
CONSOLE.
15. Return the multiline terminal and DCL-60-1
CONSOLE to the buttons side up position.
16. Connect the digital cable to the LINE jack (DT300
Series).
17. Connect the AC Adapter cable (DT300/DT700
Series) See Figure 5-85 Connect AC Adapter Cable
on page 5-78.
In case of the DSS with DT300 series, do this procedure

when extending the cable length between the SV8100
system and DT300 series.
Issue 9.0
Installed, ITL,
5 - 77