Connectors; Figure 4-15 Iplb Led Interface; Figure 4-16 Voip Connections; Table 4-17 Iplb Daughter Board Led Cn1 Transmit/Receive Data Indications - NEC Univerge SV8100 System Hardware Manual

Issue 9.0
ACT
Off
Off
On
On
Flash

4 - 38
Table 4-17 IPLB Daughter Board LED CN1 Transmit/Receive Data
Indications
data on CN1.

Table 4-17 IPLB Daughter Board LED CN1 Transmit/Receive Data Indications

LED
Link1000 Link100
Off Flash
On Flash
On Flash
Off Flash
Blinking one by one
The IPLB only supports full duplex transmission.
Refer to

Figure 4-15 IPLB LED Interface

the LED interface when installed on a CD-CP00.
3.5.5

Connectors

Figure 4-16 VoIP Connections on page 4-39
connection layout.
to a Network/PC on page 4-40
Daughter Board to a Network or PC.
shows the LED indication when transmitting or receiving
Link10
Flash
Flash Internal Error (Hardware Error)
Flash
Flash State of half duplex transmission (Not supported)
Change HUB etc. to full duplex transmission.
The firmware is being updated.
Figure 4-15 IPLB LED Interface
Figure 4-17 Connecting an IPLB Daughter Board
illustrates how to connect a VoIP
UNIVERGE SV8100
Operation Status
for a functional display of
shows a typical
Installing the SV8100 Blades