Installation; Switch Settings - NEC Univerge SV8100 System Hardware Manual

Issue 9.0
4 - 110
A digital signal processor/voice processing section handles the
following functions:
DTMF detection

DTMF generation

General tone detection

Automatic Gain Control (AGC)

Basic Support Package
Each blade installed accounts for up to 16 Extension Ports of the
Total Port capacity (One blade maximum).
Refer to the following tables for maximum upgrade capacities of the
CD-PVAA blade:
Table 2-4 SV8100 Maximum 9.5" Gateway and 19" System Capacities

– Blades on page 2-9
6.2.2

Installation

To install the CD-PVAA:
Install CompactFlash on CD-PVAA

Plug the blade into any universal slot on the chassis

Refer to Program 10-55-01 to configure the IP Address of the CD-PVAA

Refer to Program 10-55-04 to configure the Subnet Mask of the

CD-PVAA
Refer to Program 10-55-05 to configure the Gateway of the CD-PVAA

The CD-PVAA blade is hot swappable and can be removed from the

chassis without powering down the blade or the SV8100 system
When the SV8100 requires system reset, this blade comes back on line

6.2.3

Switch Settings

The CD-PVAA blade has the following switches:
Reset Switch SW3
This switch allows the technician to reset the CD-PVAA without having

to remove and reinsert the blade into the chassis.
UNIVERGE SV8100
Installing the SV8100 Blades