Connectors; Table 4-43 Cd-4Diopb Rj-61 Cable Connector Pin-Outs - NEC Univerge SV8100 System Hardware Manual

Issue 9.0
4 - 88
5.5.4

Connectors

The CN2 connector provides connection to four analogue DID trunk
ports, which are polarity sensitive (tip-to-tip, ring-to-ring). The
OPX circuits, however, are not polarity sensitive. The CD-4DIOPB
requires one universal slot. (Refer to
on page 4-86.) If Program 10-03-01 has OPX defined, note that the
blade consumes four (CD-4DIOPB) trunks and extension ports when
installed. If OPX is not defined, then only trunks ports are
consumed.

Table 4-43 CD-4DIOPB RJ-61 Cable Connector Pin-Outs

pin-outs for the RJ-61 connector.
page 4-86 shows the location of the connectors on the CD-4DIOPB
blade.
Table 4-43 CD-4DIOPB RJ-61 Cable Connector Pin-Outs
Figure 4-36 CD-4DIOPB Blade
Figure 4-36 CD-4DIOPB Blade on
RJ-61 Cable Connector – CN2
Line No. Pin No.
1 5
4
2 3
6
3 2
7
4 1
8
Installing the SV8100 Blades
UNIVERGE SV8100
shows the
Connection
Tip
Ring
Tip
Ring
Tip
Ring
Tip
Ring